Printable View
i have the rear brake assembly off for the strip down of bike etc
anyway...i have this atm http://a2.sphotos.ak.fbcdn.net/hphot...94267767_n.jpg
the rubber has a hole in it and i wanted the cylinder p-coated... but i cannot see a way of removing the plunger and spring from the cylinder.
http://a3.sphotos.ak.fbcdn.net/hphot...62650702_n.jpg
the inlet from fluid res has a circlip around it...so im assuming that would come out.
are these "re-buildable"?
cheers
Dan
Remove the rubber boot from the main shaft, this will give you access to a circlip inside, once this is out you can remove the shaft, piston, seals etc... :)
BUY
A
HAYNES. ;)
Cheap enough secondhand on ebay, saves a lot of guesswork. :P
haha ahead of u its just been delivered ;)
Why don't you just paint it? p-coat ott?
+1Quote:
Originally Posted by wiltsdan
I would have painted it? Not old enough to warrent a full strip & service?
(But thats just me) :D