View Full Version : Torque Wrench Calibration
skippernick
28-11-15, 02:24 PM
As above, does anyone know of anywhere in Trowbridge to get this done?
I dropped it.
Cheers
Nick
Looks like there's one in devizes , must get mine done too .https://www.yell.com/s/torque+wrench+calibrations-southwick-trowbridge.html
Found this , could be useful https://www.youtube.com/watch?v=uFDUsUEQrL0
pilninggas
30-11-15, 09:49 PM
I used to work for Brunel Metrology in Radstock - In my experience Torque Wrenches only go out of specification if they are preloaded (i.e you tighten a spring to set the torque) and this is left wound on.
Some cheap ones are often 5-10% off from new, but that's about the worst case scenario - that would probably fail the British Standard for accuracy, but is more than adequate in a mechanical maintenance setting even for tightening cylinder heads.
skippernick
01-12-15, 05:10 PM
Cheers guys,
Phoned that place Daddy Cool, they were a no go, despite what it said, go figure!!!
Nearest place looks like Gloucester.
Hope you are right pilninggas, as i ain't trekking up to Gloucester, i think it was 80 quid in Halfrauds and only goes to 60nm so not really cheap.
wheelers
11-12-15, 05:52 PM
not had a problem with my business ones as they are up to 40 years old. Britool, Draper, Gedore and well known names.
always keep them wound back and clean after each use. the business ones are calibrated for insurance.
cant speak for cheaper ones.
Alpha Calibration do our work ones, don't know about private but Mark the owner and Jack a technician both ride bikes.
http://alphacalibration.co.uk/about/
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.