Puncture repair in swindon

[wheelers]

the only repair we trust on a big bike is a vulcanised one, they go to a specialist take a week and cost £40. Im sure no one would tell you if they had one fail, it wouldn't be good for business , would it? that said the vulcanised repair is only recommended on specific areas. Melksham tyres advise if a repair is possible or not.
its your potential accident, its up to you when you can get a pair new for £130

[Rabb]

I've used Z rated plugged tyres without a problem.
Indeed it lasted for the rest of it's natural life (400 + miles a week)
If it's done properly - it should be OK but, remember that it has a weekness now and needs to be treated with more care than a completely sound tyre.
I have heard in the past of a tyre that was used to the end that had 16 plug repairs in it.

[SupeRDel]

Glad my 400 runs with tubes in.............

[BikeTreads]

Hey all, thought we would wade in here with our opinion on puncture repairs and some Tyre manufacturer specific info

1st off we do indeed carry out puncture repairs, the cost for this service is £15 to a loose wheel or £25 if you ride your bike in
As for the actual repair to tubeless tyres, it comes down to the size of the hole being repaired, where about's in the tyre the puncture is and how much damage if any the object has caused inside the tyre.
The process if repairing is very straight forward, after removal of the tyre, it is inspected both inside and out for visible damage and secondary damage that can be caused by running the tyre flat
If all is ok then the hole is reamed out to just under 6mm using the correct tool, the area around the hole on this inside is then cleaned of any white chalk and buffed back to leave a slightly rough texture to allow the repair to bond correctly, special glue is then applied and allowed to cure until tacky to the touch, then a mushroom plug is pulled through from the inside and using a tyre stitched it is rolled onto the glue forcing any air out and firmly bonding it to the tyre. we then apply a coat of the same glue over the top of the whole repair to add an extra layer to fully seal the repair(this is not necessary but just gives us piece of mind) All is then refitted to the wheel and inflated to the correct pressure and finally we cut the part the plug that protrudes through level with the tread.....

We will not repair tyres we feel are beyond the repair specs and of the hundreds of repairs we carry out every year we get maybe 0.1% that fail, and when they fail the tyre does destroy it self, it does not fall apart it simply looses air the same before the repair(albeit a lot slower as it now has a plug in it)
The plug it self is shaped like a mushroom, it has a round head at one end, approx 25mm wide and this is the part that repairs the inner part of the tyre(the part that holds the air in) attached to the head is a long stem that is used to pull the repair through, this serves 2 purposes, 1 of which is to plug the hole, the second is to pull the repair securely to the inside of the tyre...

Have a look at the link below for Michelins guide lines on repairs to their tyres
http://moto.michelin.co.uk/advice/fa...nce-and-repair

All tyre manufacturers have their own guide lines on repairs to their tyres and if they even allow them to be repaired(this is for warranty purposes)
We then repair in accordance with legislation

Sorry if this is a little long winded but we want to make it as clear as possible so you can choose if you repair or replace your tyre with as much information as possible.
Either way we are able to repair if you need and if not we can replace your tyre, we carry a very wide range in stock

[Dan]

The tyre repair bike treads has held up - shame the rest of the bike hasn't!

[WR6133]

It's died again?

[Burbler]

Hey all, thought we would wade in here with our opinion on puncture repairs and some Tyre manufacturer specific info

{Large Snip}

Sorry if this is a little long winded but we want to make it as clear as possible so you can choose if you repair or replace your tyre with as much information as possible.

Not long winded at all for me. Excellent info on a widely mis-understood subject.

Thanks.

[Dan]

It's died again?

Yes pops the main 30a fuse as soon as you turn the key. Ran out of patience with it.

[WR6133]

Yes pops the main 30a fuse as soon as you turn the key. Ran out of patience with it.

Give you £20 and a spark plug for it!

Guessing a bad earth somewhere. Maybe pinched a wire somewhere when you put it back together?

[Dan]

Having my sister and a crying baby in the house over the weekend lead me to dig the bike out after a month of ignoring it..



This is the main earth for the entire wiring loom. Broken, burnt and tucked away behind the rear brake reservoir.

Can't find the rest of that cable though.......