|
|
07-10-11, 06:12 PM
i have the rear brake assembly off for the strip down of bike etc
anyway...i have this atm
the rubber has a hole in it and i wanted the cylinder p-coated... but i cannot see a way of removing the plunger and spring from the cylinder.
the inlet from fluid res has a circlip around it...so im assuming that would come out.
are these "re-buildable"?
cheers
Dan
08-10-11, 09:42 AM
Remove the rubber boot from the main shaft, this will give you access to a circlip inside, once this is out you can remove the shaft, piston, seals etc...
BUY
A
HAYNES.
Cheap enough secondhand on ebay, saves a lot of guesswork. :P
08-10-11, 10:08 AM
haha ahead of u its just been delivered
08-10-11, 10:22 AM
Why don't you just paint it? p-coat ott?
08-10-11, 12:32 PM
+1Originally Posted by wiltsdan
I would have painted it? Not old enough to warrent a full strip & service?
(But thats just me)
| « Previous Thread | Next Thread » |
