Hi
Can anybody advise how tight I should do the bolts holding the screen? (Honda CBF)
I've guessed at tightening them and then slackening off a bit to allow a little flexing. No idea if this is right though.
Any advice gratefully accepted.
|
Hi
Can anybody advise how tight I should do the bolts holding the screen? (Honda CBF)
I've guessed at tightening them and then slackening off a bit to allow a little flexing. No idea if this is right though.
Any advice gratefully accepted.
Personally i wouldn't allow for any movement as there are just as likely to loosen and fall out, if its the rubber type fixings just tighten them up as normal, i usually apply a little grease to the thread to allow for easy removal
Copaslip to the threads, in fact to any threads on the bike you want to come out again.
I tend to use an oxide inhibiting paste we get at work, copaslips ok, but i wouldn't use it on alum fittings due to the reaction between dissimilar metalsOriginally Posted by Mitch9128
« Previous Thread | Next Thread » |