So i've just got some clear stuff and am after any tips on getting a decent fit
|
|
29-06-09, 10:12 AM
So i've just got some clear stuff and am after any tips on getting a decent fit
29-06-09, 10:57 AM
Clean the area very very very well, Also when i fitted mine i heated up both the tank and the back of the grip with a hair dryer and then slapped them on pushing out any bubbles straight away. Make sure it is as clean as poss and warm and you will be fine.
Once they stick they stick though so you may struggle if you stick it wrong the first time round
30-06-09, 01:10 PM
Hairdryer! Only peel off a little backing at a time as you apply the grip and press down firmly to get rid of the bubbles [smiley=thumbsup.gif]
30-06-09, 01:54 PM
Well done it now.....what a fooking pain in the arse, one sides mint the other has a few bubbles
30-06-09, 06:06 PM
Stick a pin though the bubble and push the air out, should help a bit?
01-07-09, 10:21 AM
It's bubbles in the resin so doubt that would work mate, it's not too bad tbhOriginally Posted by noisy_lightning
| « Previous Thread | Next Thread » |
